TSC-TTP-247 - Loading Ribbon and Media/Labels
Reference Number: AA-00377 Views: 5590 Created: 2014-04-02 10:51 Last Updated: 2014-10-14 13:14 0 Rating/ Voters

Loading the Ribbon

Loading the ribbon on the TSC-TTP-247 can be a tedious process. Follow the instructions below or watch this 3rd party video from minute 4:24 to see how it is done. =>  https://www.youtube.com/watch?v=-HKW0rrg4i8


Steps:

1. Pushdown on the ribbon access windows to open it.

2. Installa ribbon on the Ribbon Supply Spindle. (Introduce spindle into the ribbon from right-to-left) 

3. Mountthe ribbon supply spindle on the rear hubs.

4. Placea paper core onto the ribbon rewind spindle. 

5. Mountthe ribbon rewind paper core on the front hubs.

6. Openthe printer's top cover by releasing the green top cover open levers located oneach side of the printer.

7. Pullthe ribbon through the print head and then stick the ribbon onto the ribbonrewind paper core. 

8. Rotatethe ribbon rewind paper core until the black section of the ribbon covers theprint head. Make sure the DULL side faces you. Shiny side should not face you. 

9. Closethe ribbon access window and printer cover.


Loading The Media/Labels

 Follow the instructions below or watch this 3rd party video from minute 5:41 to see how it is done. =>  https://www.youtube.com/watch?v=-HKW0rrg4i

Steps:

1. Open the printer's top cover by releasing the green top cover.

2. Insert a 1" label spindle into a paper roll. (Usually green spindle)

3. Place a roll of paper onto the center of the paper roll mount.

4. Feed the paper, printing side face up, through the Teflon bar and the paper guide and pass over the plate.

5. Adjust the green center-biased paper guides to slightly touch the edges of the label backing.

6. Lift the cover to the ultimate open angle then use both hands to close the convert gently.





A


Quick Jump Menu